Radar Senate Graphite 67 2014 and reflex bindings

where exactly should I assemby the reflex front plate size 10xl on the Radar Senate Graphite 67 2014?
thanks in advance.


  • chris_loganchris_logan Posts: 355 Solid Baller
    I would set the boot on the plate (not under tension), then on the ski, and adjust it until the back edge of the heel (nearest the plate) is at 29.25" or ~74.3cm as a good starting point. Don't just choose holes - always measure.
    Always looking for a pull... Will you be my boatdriver?
  • HortonHorton Posts: 25,935 Administrator

    Support BallOfSpray by supporting the companies that support BallOfSpray

    Connelly • D3 • DBSkis • Goode • Hobe Lake • HO Syndicate • MasterCraft 

    Masterline • O'Brien • Performance Ski and Surf • Reflex • Radar • Stokes

  • warsaw_skiwarsaw_ski Posts: 6 Baller
    Thank You)
  • eddie_roberts_jreddie_roberts_jr Posts: 447 Water Ski Industry Professional
    Like Horton says 30" from the heel of your Reflex front boot to the top edge of the tail of the ski will put you right in the ballpark.
  • warsaw_skiwarsaw_ski Posts: 6 Baller
    Can i have one more question, cuz i'm wondering should i mesure the distance from point A or B?

    like on the picture

    Or should i mount it as in the irstuction reflex manual on the site 8?? link below


    Thanks in advance
  • DeanoskiDeanoski Posts: 748 Crazy Baller
    point a below the heel block
  • warsaw_skiwarsaw_ski Posts: 6 Baller
    that is, at point A?
  • warsaw_skiwarsaw_ski Posts: 6 Baller
    Horton Posts: 14,215 Administrator
    April 13 edited April 13 Flag
    IMPORTANT NOTE - Binding placement is super important. On my first ride I was at 30.25 and the ski sort of sucked. I moved the bindings back to 30 and KaPow! the ski came to life. You may think that since this is not a $1,400 ski that settings are not important... you would be wrong.
  • warsaw_skiwarsaw_ski Posts: 6 Baller
    as you can see it is important to find the point
Sign In or Register to comment.