Forgive me if this has been discussed previously. I did try a number of searches and couldn't find an answer to this.
My ski buddy has a 2018 Senate Alloy which doesn't have a fully adjustable fin block. I doubt I'll be using my old Monza anymore so I could let him use the adjustable fin block from it on his Alloy. Could that be made to work? Would it require drilling new holes in his Alloy or would it be a direct swap? Neither ski are anywhere close to where we are right now so we can't look at them to see if the bolt pattern is the same. Then there's the issue of fin widths. Not sure if one company's fins are narrower/thicker than the other's.
TIA
I can take anything apart
0
Comments
Support BallOfSpray by supporting the companies that support BallOfSpray
Connelly ☆DBSkis ☆Denali ☆Goode ☆GiveGo ☆MasterCraft ☆ Masterline
Performance Ski and Surf ☆ Reflex ☆ Radar ☆ Rodics OffCourse ☆ S Lines ☆ Stokes ☆