Howdy, Stranger!

It looks like you're new here. If you want to get involved, click one of these buttons!

______________
12" White Stickers
______________
BallOfSpray $5 Donation
______________
BallOfSpray $10 Donation

Radar Strada binding setup on Syndicate Omni.

nam1975nam1975 Posts: 140 Baller
Does this need to be adjusted at all from the 29.5” on HO website?
I seem to remember a slight adjustment when I put this binding on my D3?

Thanks for any input!

Comments

  • BraceMakerBraceMaker Posts: 3,777 Mega Baller
    Of all the numbers I find the binding initial measurement to be the least useful.

    If you consider set up of several different bindings, say your Radar, a Reflex, a Wiley's, where your ankle sits in relationship to the heel of the boot can be significantly different, even the different liners you can buy for hardshells change them quite a lot.

    I would probably start by measuring your current binding on the D3, if you find that you are 1/4" forwards of recommended numbers I would probably start there and try moving a bit closer to the factory number set after set.
    nam1975
  • Ski_DadSki_Dad Posts: 395 Baller
    i have an HO ski and when I set my Radar Vector (Alum Plate) in the middle hole it was right with the recomenmdation for my ski - and it feels right. Did the same thing for my boys CX ski
  • Chef23Chef23 Posts: 5,961 Mega Baller
    Easier from the stitching on the back of the bottom of the Strada.
    Mark Shaffer
    nam1975
  • ALPJrALPJr Posts: 1,874 Mega Baller
    I have double Vapor boots and a Sequence plate on a HO. Got them right where I want them.
Sign In or Register to comment.